Without knowing any details (aircraft, weather settings (temperature!), configuration, altitude, airspeed etc.) it is hard to determine if the behaviour you are seeing is indeed a "bug" or indeed realistic.Besides, not all FlightGear aircraft can currently be considered to be functional, some have a pretty basic FDM that will only work properly within a certain flight envelope.The citation is a good example for this: it's an excellent model and features an awesome 3D cockpit, however its FDM is barely flyable-unfortunately. How do I prevent the>above two from happening?So, there are many things that need to be taken into account. >and so far I have not managed to land any plane and>keep it on the ground a single time either it crashes (gets>stuck) or bounces into the air again. Likewise, the weather settings may also influence the aircraft's peformance.Apart from that I am not sure if you are familiar with the fact that IAS (indicated airspeed) necessarily decreases at altitude, even though your TAS (true airspeed) and ground speed may be totally sufficient. stall?), you will want to verify that you are using a proper AoA and configuration (flaps, gear). However, if you slow down ridiculously (i.e. If I turn>in small increments, nothing seems to happen at all.How exactly do you control FlightGear (keyboard,mouse,joystick/yoke), is this a general problem, or does it also occur if you switch control mode?And what's the value of your /sim/model-hz property?Have you tried adjusting this value to your hardware?Also, does the same problem occur if you use the autopilot to control the aircraft?>Also,whenever I climb, I will start to lose airspeed drastically>after some time,regardless of the angle of incline of the elevator, in general, climbing usually entails an decrease in airspeed, so you have to compensate for this by increasing thrust. When I do the same to the>YF-23, it pitches to the left and starts to stall. For example, when I turn the 737 right, it will start>pitching and diving dangerously. Regarding the terrain follow, I'm experiencing the>problem for most of the planes I've flown so far (such as the>Cessna 172, Boeing 737, YF-23, etc.), and as for the wind>speed, I've already turned wind off.Are using any sort of input hardware (joystick,yoke,pedals)?If so: are you sure that your controls are in a centered/neutral position?>And I also seem to be experiencing problems turning the>planes. >Ok, I'm not sure about the FDM version, but I'm using FG>0.9.9.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |